Work package 3: Analysis and Characterisation
At the Institute for Surface and Coating Technology (IFOS), process‑coordinated chemical and morphological analyses are carried out to develop sustainable cutting tools. The focus is on both model specimens and powder materials as well as additively manufactured blanks and final tools. The goal is to understand relationships between manufacturing processes, microstructure, interface chemistry, and subsequent performance, and to optimally target the developed material and process concepts. To this end, IFOS employs modern instrumental surface and material analytics to investigate micro‑structure, phases, defects, surfaces, and interfaces from micrometer to nanometer scale.
The work package is divided into two sub‑areas:
AP 3.1 – Characterisation of additively manufactured WC/Co materials from recycled resources
The focus here is on the chemical and morphological analysis of powders, model specimens, blanks, and tools made from (recycled) WC/Co material. Among other aspects, particle properties, phase formation, impurities, micro‑structure, and defects resulting from additive manufacturing and mechanical loading are examined. The results serve both process optimisation and validation as well as improvement of simulation models.
AP 3.2 – Characterisation of alternative material combinations and coating systems
To reduce or replace hard‑metals, alternative material combinations and hard‑material coatings are investigated. The focus is on the chemical and morphological properties of surfaces and interface layers and their influence on adhesion, residual stresses, wear behaviour, and tool life. These analyses support optimisation of surface pre‑treatments, coating processes, and material selection.
Sub‑project lead
Dr. rer. nat. Swen Ehnert
E-Mail: ehnert(at)ifos.uni-kl.de
