Work package 2: Alternative material concepts for milling tools

The Materials‑Testing Working Group (AWP) focuses on identifying suitable materials and material states for substituting cobalt and tungsten in hard‑metal tools. The following research questions will be addressed:

  • Which alternative materials and material states are viable for substitution?
  • Can the properties of alternative materials—especially in highly stressed surface layers—be improved through novel heat treatments?
  • Are mechanical properties equivalent to those of conventional hard‑metal materials achievable with the alternative material concepts?

The work package is divided into three successive sub‑areas:

 

WP 2.1 – Selection of Potential Replacement Materials

A systematic material selection is performed using so‑called Ashby maps. This process uses the specific properties of conventional cutting tools to identify potential replacement materials. In addition, these candidate replacement materials are evaluated, especially with regard to their environmental impacts, service life / recyclability, and possible links to human‑rights violations. Moreover, preliminary results concerning the forces acting on the tool from simulations and run‑time tests are taken into account.

In addition to concepts already discussed in the literature—such as partial substitution of the binder with iron or nickel, or complete replacement with iron aluminides—this work also considers special iron alloys with excellent wear resistance, e.g., nano‑bainitic steels. Novel treatment methods, especially combinations of heat treatments and cryogenic treatments, aim to induce targeted precipitation of carbides near the surface of these alloys, thereby further improving the properties of the substitute materials.

The primary goal of these treatments is to adjust the microstructure and precipitation distribution within the surface layers such that the materials become suitable for use as cutting tools.

 

WP 2.2 – Production of Specimens from the Defined Replacement Materials

Once potential replacement materials have been identified, specimens of the two most promising options are fabricated and, if necessary, subjected to heat treatment. These specimens are then forwarded to the subsequent sub‑work package where they are tested and compared with conventional tools. If the tests prove successful, blanks made from the most promising substitute material are produced; these are then sent for tool manufacturing and subsequently for testing in the machining process.

 

WP 2.3 – Material Testing of Known and New Materials for Hard‑Metal Milling Tools

Both conventional hard metals for traditional tools as well as additively manufactured materials and the new alternative materials are subjected to various material‑testing methods. In addition to classic tests such as tensile and fatigue strength tests, instrumented hardness measurements and impact tests (Charpy) are also employed; these latter investigations can provide insight into the material behavior under localized, limited force application. Instrumented hardness measurement allows obtaining specific information about hardness and elastic modulus across a material’s cross‑section, which can then be used in simulations. The microstructure of the materials is characterized over multiple scales. The goal is to compare the investigated materials and manufacturing routes within this project—particularly regarding the properties determined during the tests—with conventional cutting‑tool materials, thereby assessing whether substitution is possible.

 

Sub‑project lead

Prof. Dr.-Ing. Eberhard Kerscher

E-Mail: e.kerscher@rptu.de

Research Associate

Dr. Sumit Ray

E-Mail: s.ray@rptu.de