Vikki Franke
Research Engineer at FBK from June 2006 till August 2011.
Publications
Books
Franke, V.: Einfluss der Werkzeugschneidkante auf die Bohrungsqualität bei der spanenden Bearbeitung langfaservestärkter Kunststoffe. In In: J.C. Aurich (Hrsg.): Produktionstechnische Berichte aus dem FBK. Band 04/2010. Kaiserslautern: Techn. Univ., 2010. Zugleich Kaiserslautern, Techn. Univ., Diss., 2010.
Journals
Aurich, J.C.; Dornfeld, D.; Arrazola, P. J.; Franke, V.; Leitz, L.; Min, S. (2009): Burrs - Analysis, Control and Removal (Keynote Paper). In CIRP Annals - Manufacturing Technology (58/2), pp. 519–542.
Franke, V. (2011): Drilling of long fiber reinforced thermoplastics - Influence of the cutting edge on the machining results. In CIRP Annals - Manufacturing Technology (60/1), pp. 65–68.
Franke, V.; Hielscher, T.; Aurich, J.C. (2009): Spanende Bearbeitung glasfaserverstärkter Thermoplaste. In wt Werkstattstechnik online (99/11-12), pp. 873–879.
Leichner, T.; Franke, V.; Sauer, B.; Aurich, J.C. (2011): Investigation of the Tribological Behavior of Radial Shaft Rings and Soft Turned Shafts under the Influence of Abrasive Particles. In Production Engineering - Research and Development (5/5), pp. 531–538.
Leitz, L.; Franke, V.; Aurich, J.C. (2009): Beherrschung der Gratbildung bei Bohrungsverschneidungen. In ATZproduktion (2/2), pp. 22–27.
Conferences
Aurich, J.C.; Leitz, L.; Franke, V.; Hielscher, T. (2008): Approaches on Burr Control when Drilling. In Proceedings of the 3rd International Conference High Performance Cutting, pp. 3–11.
Eyrisch, T.; Franke, V.; Sauer, B.; Aurich, J.C. (2010): Hard Turning of AISI 4140 - Influence of Tool Geometry and Cutting Parameters on Chip Formation and Surface Integrity. In Proceedings of 4th CIRP International Conference on High Performance Cutting 2, pp. 317–320.
Franke, V.; Leitz, L.; Aurich, J.C. (2009): Burr Measurement: A Round Robin Test comparing different Methods. In Proceedings of the CIRP sponsored International Conference on Burrs: Analysis, Control & Removal, pp. 167–180.
Leitz, L.; Franke, V.; Aurich, J.C. (2009): Burr Formation in Drilling Intersecting Holes. In Proceedings of the CIRP sponsored International Conference on Burrs: Analysis, Control & Removal, pp. 99–106.